STEP BY STEP TUTORIAL
- Print the selected artwork on Sublimation Paper using Sublimation Printer.
- Attach Crystal Trophy onto the printed Sublimation Paper using Heat Resistant Tape.
- Set the Heat Press Machine to 200 Celsius for 200 seconds.
- Remove the Silicone Pad. Place Sponge Foam and Newsprint Paper on top of the platen.
- Next, place the Crystal Trophy face up and place Newsprint Paper on top of it.
- Cover with Teflon Sheet and start to heat press. (pre-adjusted with light pressure).
- Once the 200 seconds are up, rotate it 90 degree and continue to heat press for another 50 seconds.
- The timer will be reset when the Heat Press Machine is released.
- Release the Heat Press Machine when the timer is 150 seconds.
- Move the Crystal Trophy aside and allow it to cool down. (approximately 20 minutes)
- Caution, it is very hot at this stage!
- After the Crystal Trophy is cooled down, immerse in water and remove the Sublimation Paper
- Squeeze some portion of Epoxy Bond (AB Glue) on unused substance (e.g. tiles, plate & etc) and mix well.
- Apply the mixed glue on the bottom of the Crystal Trophy then stick it with the base and leave it for 5 minutes.
- You are done!